geberit EFP 203 Manual página 27

Cancelling the pressing
procedure
▶
Press and hold release button.
Rectifying malfunctions
Fault
Pressing tool cannot be
started.
Pressing tool stops
moving.
36028798914619019 © 08-2022
968.393.00.0(01)
Result
✓ The roller drive in the pressing tool
Cause
Mains cable is not
connected.
Mains cable or mains
plug is defective.
Network failure
returns to its starting position. The
pressing procedure must be repeated for
a complete press connection. The
pressing attachment must not be
removed or rotated at this time.
Action
▶ Connect the mains plug to the power
supply system.
▶ Have the mains cable and mains plug
examined at an authorised repair
shop and replaced if necessary.
▶ Release start button.
▶ Press and hold release button: roller
drive moves to its starting position.
▶ Check the pressfitting for tightness
and repeat the pressing operation if
necessary.
EN
27