IKRA IROM 600 Instrucciones De Manejo página 31

1. Once the boundary wire has been installed,
you can start up the robot mower (see
instructions for installing the boundary wire).
Press POWER ON/OFF,
until the robot mower switches on.
2. Enter the default PIN code 0000 the first time
you use the device by pressing OK four times,
until the number „0" flashes. (The PIN code
can be changed (see 6) Settings).
NOTE: The robot mower switches off if it
does not receive any input within 30 seconds
of being switched on.
If you enter an incorrect PIN code ten times,
the robot mower emits an alarm tone and
then switches off.
3. Press START and then OK to start mowing.
4. Press HOME and then OK
PIN
2. Setting the year, date and time
Setting the year, date and time is a matter
of course. If you do not make this setting, this
will affect the scheduling and other settings.
These elements should be set in the order of
year, date and time.
To set the year, press „START" for 5 seconds
and the robot mower returns to the charging
station.
The robot mower operates continuously until
the battery level is low and then returns to
the charging station. As soon as charging is
complete, the robot mower automatically
resumes mowing or remains in the charging
station, depending on the mowing schedule.
6) Settings
1. To change the PIN code, press the „START"
and „HOME" buttons simultaneously for 3
seconds."
The „lock" symbol
i.e. you must enter the old PIN (0000). After
„PIN 1" is displayed, the first number flashes.
Use „START" or „HOME"
to select the number. Press „OK".
The next number flashes. Repeat the process
until the old PIN has been entered.
You can now set your new PIN. The new PIN
code is „1234", for example. After you have
entered your old PIN, „PIN 2" flashes and
the first number flashes again. Enter the
desired new PIN code in the same way (in this
example „1234"). The display then shows
appears on the display. Your PIN code has
been successfully changed.
until the „CLOCK" symbol
and a number flash on the display, e.g.
2020 .
Use „START" or „HOME"
GB
ENGLISH
flashes, „PIN 1" flashes,
31