Vortice VORT HR 450 AVEL D Manual De Instrucciones página 38

ENGLISH
11 Use
Appliance is automatically managed by an electronic control system. Appliance can automatically choose the most suitable
operating mode, depending on the outside temperature.
When the appliance is switched on, both motors will run at a really slow speed for 3 minutes to allow repositioning of the
by-pass valve. After, motors will start up again. NOTE: this is a normal system procedure and should not be perceived as
a malfunction.
11.1 General
B
A
11.2 Meaning of icons/buttons in the touch area:
1
1
3
38
All functions can be controlled via the on-board control panel equipped
with touch screen:
A: touch area
B: display
3. date/time (last line of the display) and Prog/Man display;
4. T Ext, T Int, T Exh, T Sup display (last two lines of the display);
4
5. Exit without saving and return to the previous page
6. Speed increase (OFF, 1, 2, 3, Boost) either moving the cursor to
the line above or increasing the value;
5
7. Speed decrease either moving the cursor to the line below or
decreasing the value;
8. Confirmation of the current choice and go to the next page with
saving of current data.
6