Brandt BPI 384 HUB Guia Del Usuario página 34

USE USE
Horizone Piano Function
Activate the Horizone function by pressing the
key briefly
to activate the Horizone Piano function.
This function allows you to cook on high heat
in the front part of the Horizone zone and keep
warm in the back part of the Horizone zone. This
is the default setting. You can customize the
power settings of the Horizone Piano function
with the "+" and "-" power buttons.
L = Keep
zone - line in the middle of the display).
H = high heat zone.
Pressing the "+" of the power setting will
switch to the higher power (the line will be
on top) and pressing the "-" will switch to the
lower power (the line will be on the bottom).
The default values can be changed by pres-
sing and holding the "-" key. The zones can
be switched at the same time as the de-
fault values are set. When changing the de-
fault value from L (3) to the minimum power
(1), pressing the "-" key does not decrease
the power, so the line remains in the middle.
Similarly, when the default value of H (12)
is changed to the maximum power (14),
pressing the "+" button does not increase
the power, the line remains in the middle.
The Boost and Boil functions do not work with
the Horizone Piano function.
Only one timer works for both Horizone Piano
zones.
14
, and then pressing the key
warm zone (rear
CHILD SAFETY
Your hob has a child lock which locks the controls
when the appliance is switched off or during
cooking. For safety reasons, however, the
button remains active and allows the heating
zones to be switched off even when locked.
Locking :
Press the
appears and a beep confirms your operation
The display of the operating cooking zones now
shows the power and the lock symbol alternately.
The display of the operating cooking zones now
shows the power and the lock symbol alternately.
Unlocking :
Hori-
Press the button until the
sappears and a beep confirms your operation.
CLEAN LOCK function:
The Clean Lock function allows the table to be
temporarily locked during cleaning.
To activate the Clean Lock function, press the
button briefly, a beep will sound and the
symbol will flash. After about 1 minute, the lock is
automatically deactivated. A double beep is heard
and the
tivate the Clean Lock function at any time by
pressing and holding the
button until the
symbol
symbol disappears. You can deac-
button.
EN
lock symbol
di-