PRESIDENT JOHNSON II Manual Del Usuario página 30

Scan of the memories
a) press MEM (9) during the scanning cycle of the channels. «MEM» is dis-
played. The transceiver scans the active memories (M1, M2, M3) and
channels 19 and 9.
b) press MEM (9) during recall cycle of the channels. «SCAN» is displayed,
«MEM» disappears.
Press PTT (11), CH19/9 (5) , DW (6) or SCAN (7) again to exit SCAN function.
M2
(see § 9)
8) AM/FM ~ LOCAL ~ M1
AM/FM
(short push)
This switch allows to select the modulation mode AM or FM.
Your modulation mode must correspond with the one of the person you
are speaking to.
AM/ Amplitude Modulation (AM) is for communications in areas where
there are obstacles and over medium distances.
FM/ Frequency Modulation (FM) is for nearby communications in flat,
open areas.
AM/FM
2 function (only in U configuration)
nd
Allows to alternate the frequency bands CEPT and ENG in the U config-
uration. When the ENG frequency band is selected, «UK» is displayed.
LOCAL
(long push)
This feature allows a better listening through close contact. When your
partner is close, press this button to avoid distortion.«LOCAL» is displayed.
M1
(see § 9)
9) MEM ~ F
MEM
3 channels can be memorized with following parameters: AM (except
for EC and U configurations) or FM; LOCAL; NB/ANL; HICUT (and CEPT/
ENG in the U configuration)
To memorize:
- Press shortly on MEM (9), «MEM» blinks.
- Press during 1 s on M1 (8), M2 (7) or M3 (6). «MEM» is displayed contin-
uously. The channel has been memorized.
To recall a memory:
- Press shortly on MEM (9), «MEM» blinks.
- Press shortly on M1 (8), M2 (7) or M3 (6).
- «MEM» is displayed continuously. The memorized channel is active.
To delete a memory:
- Turn off the transceiver.
- Keep key M1, M2 or M3 pressed and switch on the transceiver.
- The selected memory is deleted.
F - FREQUENCY BAND SELECTION
(Configuration: EU ; PL ; d ; EC ; U ; In)
The frequency bands must be chosen according to the country where
you are going to operate. Do not use another configuration. Some
countries require user's licence.
See the table on page 49.
How to proceed:
- Switch off the transceiver
- Press and hold the F (9) key and switch on the transceiver. «F» blinks and
the letter corresponding to the configuration blinks.
- In order to change the configuration, use the /t keys on the front
panel or UP and DN on the microphone.
- When the configuration is selected, press on the F (9) key during 1 s.
«F» and the letter corresponding to the configuration is continuously
displayed. At this stage, confirm the selection by switching off then
switching on again the transceiver.
See tables on page 44 ~ 48.
10) 6-PIN MICROPHONE PLUG
This plug is situated on the front panel, thereby making it easier to set
the equipment into the dashboard. See the cabling diagram on page
47.
11) PTT (push to talk)
Press this knob to transmit a message and release to listen to an incoming
communication.
30