Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING
uct unless instructed otherwise in this manual or by the
manufacturer. Do not use attachments or accessories
that are not recommended for use with this product.
Making unauthorized modifications and using incom-
patible accessories can damage the unit and may void
your warranty.
WARNING
until assembly is complete. Failure to comply could
result in accidental starting and possible serious per-
sonal injury.
INSTALLING TUBE FRAME AND AXLE
See Figure 5.
z Place the snow blower upside down in a stable position.
z Align the tube frame and axle as shown.
z Place the tube clamps over the open end of the frame
and secure with four of the hex screws with the included
hex wrench.
z Secure the U part of the frame with the remaining hex
screws.
NOTE: Be careful not to over tighten the screws.
INSTALLING THE WHEELS
See Figure 6.
z Locate the two wheels, wheel caps, four washers, and
two cotter pins.
z Place one washer onto the axle.
z Slide a wheel onto the axle, followed by a second washer.
z Insert a cotter pin through the hole on the axle. Bend the
longer side of the pin away and over the axle to secure
the wheel in place.
z Align the tabs on the wheel cap with the slots on the wheel
and press to lock into place.
z Repeat for the other wheel.
INSTALLING THE ASSIST HANDLE
See Figure 7.
Use the assist handle to lift the unit.
z Align the assist handle to the outside of the snow blower
as shown.
z Insert the screws and tighten firmly. Do not overtighten.
Do not alter or modify this prod-
Do not connect to power supply
FIG. 5
D
A - Snow blower
B - Tube frame and axle
C - Tube clamps
D - Screws (6)
FIG. 6
B
E
C
A - Axle
B - Washer
C - Wheel
D - Cotter pin
E - Wheel cap
FIG. 7
B
A - Assist handle
B - Screws (4)
English
|
10
B
C
D
B
A
A
A
Publicidad
