Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING
ucts to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
WARNING
side shields marked to comply with ANSI Z87.1. Fail-
ure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories
not recommended can result in serious personal injury.
NOTICE
Before each use, inspect the entire
product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fas-
teners and caps and do not operate this product un-
til all missing or damaged parts are replaced. Please
contact customer service or a qualified service center
for assistance.
WARNING
from power supply when you are assembling parts,
making adjustments, cleaning, or when not in use.
This will prevent accidental starting that could cause
serious personal injury.
CONNECTING TO POWER SUPPLY
See Figure 13.
This product is designed with a cord retainer that prevents
the extension cord from coming loose while in use.
z Form a loop at the end of the extension cord.
z Insert the loop of the extension cord through the bottom
opening ot the power cord retainer.
z Place the loop over the hook. Lightly pull on the cord to
reduce the slack and secure it over the hook.
z Plug the snow blower into the extension cord.
NOTE: Removing all excess cord slack will prevent the
plug from loosening from the extension cord.
STARTING AND STOPPING THE SNOW
BLOWER
See Figure 14.
To start the motor:
z Connect the snow blower to power supply.
NOTICE
Always secure extension cord to the
unit by using the power cord retainer. Failure to use
the power cord retainer may result in damage to the
snow blower and/or extension cord.
Do not allow familiarity with prod-
Always wear eye protection with
Do not use any attachments or
Always disconnect snow blower
FIG. 13
A
A - Power cord retainer
B - Extension cord
FIG. 14
A
A - Start button
B - Bail
z Press and hold the start button.
z Pull and hold the bail against the handle to start the unit.
Release the button but continue holding the bail to the
handle.
To stop the motor:
z Release the bail.
English
|
13
B
Publicidad
