Descargar Imprimir esta página

Carrera RC Turnator Instrucciones De Montaje Y De Servicio página 3

Ocultar thumbs Ver también para Turnator:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
360° Drehung
12
Durch langsames entgegengesetztes und gleichmäßiges Auf- und Abbewegen der beiden Joysticks
dreht sich das Fahrzeug 360° auf der Stelle.
Dank 2,4 GHz Technologie können bis zu 16 Fahrzeuge gemeinsam auf einer Renn strecke gefahren
13
werden. Dies ist ganz ohne Frequenz-Abstimmung unter den Rennfahrern möglich.
Problemlösungen
Problem: Modell fährt nicht.
Ursache: Schalter am Controller oder/und Modell steht/stehen auf „OFF".
Lösung: Einschalten.
Ursache: Schwacher oder gar kein Akku im Modell.
Lösung: Geladenen Akku einlegen.
Ursache: Das Auto ist an einem Hindernis stehen geblieben.
Lösung: Der Überspannungsschutz hat das Auto abgeschaltet. ON/OFF Schalter am Fahrzeug einmal auf
OFF, dann wieder auf ON schalten und auf einer freien Fläche platzieren.
Ursache: Schwacher Akku/Batterie im Controller oder Modell.
Lösung: Geladenen Akku oder Batterie einlegen.
Ursache: Der Controller ist ggf. nicht richtig mit dem Empfänger im Modell gebunden.
Lösung: Stellen Sie wie unter „Jetzt kann die Fahrt los gehen" beschrieben, eine Bindung zwischen Modell
und Controller her.
Ursache: Innerhalb von ca. 30 Minuten Stillstand schalten sich Controller und Fahrzeug von selbst aus.
Lösung: Zum erneuten Gebrauch bitte den ON/OFF Schalter an Controller & Fahrzeug einmal auf OFF und
anschließend wieder auf ON schalten.
Ursache: Das Fahrzeug ist sehr warm.
Lösung: Fahrzeug und Controller ausschalten und das Fahrzeug etwa 30 Minuten abkühlen lassen.
Ursache: Der Überhitzungsschutz hat das Auto wegen zu starker Erwärmung angehalten.
Lösung: Den Empfänger ausschalten. Das RC-Fahrzeug etwa 30 Minuten abkühlen lassen.
Problem: Keine Kontrolle.
Ursache: Fahrzeug setzt sich ungewollt in Bewegung.
Lösung: Zuerst das Fahrzeug einschalten, dann erst den Controller.
Irrtum und Änderungen vorbehalten · Farben / endgültiges Design – Änderungen vorbehalten
Technische und designbedingte Änderungen vorbehalten · Piktogramme = Symbolfotos
Dear customer
Congratulations on purchasing a Carrera RC model car, manufactured in accordance with the latest technol-
ogy. As it is our constant endeavour to develop and improve our products, we reserve the right to make
modifications, either of a technical nature or with respect to features, materials, and design, at any time, and
without prior notice. For this reason, no claims will be accepted for any slight deviations in your product from
the data and illustrations contained in these instructions. These operating and assembly instructions are an
integral part of the product. Important! Please read this manual carefully and keep these instructions for future
reference and in the event that the product is passed on to a thrid party.
For the latest version of these operating instructions and information on replacement and spare parts
avail able, please visit
carrera-rc.com
in the service area.
Declaration of conformity
Carrera Toys GmbH hereby declares that this model including the controller conforms with the fundamental require-
ments of the following EC directives: EC Directives 2009/48/EC and the other relevant regulations of Directive
2014/53/EU (RED). The original declaration of conformity can be requested from carrera-rc.com.
Maximum radio-frequency power transmitted <10 dBm · Frequency range: 2400 – 2483.5 MHz
Warning!
Inappropriate use may result in severe injuries and/or damage to property. It has to be operated with care and
caution and requires both mechanical and mental skills. The operating instructions contain notes on safety and
technical regulations as well as information on maintaining and operating the product. It is indispensable to read
these instructions thoroughly before the first usage. Only this helps to avoid accidents with injuries and damage.
WARNING!
This toy contains small parts which can be swallowed and is therefore not
suitable for children under 3 years of age.
WARNING! danger of pinching during operation! Remove all packaging materials and
wire fastenings before handing the toy over to the child. Please retain the packaging
and address for information and in the event of any questions.
This symbol, showing refuse bins with a cross through them, denotes that empty
batteries, rechargeable batteries, button cells, rechargeable battery packs, equipment
batteries, disused electrical equipment, etc. should not be disposed of in domestic
refuse, as they are harmful to the environment and health. Do not mix dissimilar bat-
tery types or employ new and used batteries together. Rechargeable batteries are
only to be charged by adults. Empty batteries should be removed from the product. Do not recharge non-
recharge able batteries due to risk of explosion. Never use damaged batteries. Remove batteries if consumed or
if product is to be left unused for a long time. Always replace the whole set of batteries at one time, taking care
not to mix old and new ones, or batteries of different types.
Rechargeable batteries are to be removed from the toy before being charged. Batteries are to be inserted with
the correct polarity. Supply terminals are not to be short circuited.
The appliance is only to be used with the power supply unit provided with the appliance. The use of a different
power supply unit may lead to the permanent damage of the battery and neighbouring parts, as well as
WARNING: For the purposes of recharging the battery, only use the detachable supply
physical injury!
unit provided with this toy.
Battery chargers used with the toy are to be regularly examined for damage to
the cord, plug, enclosure and other parts, and in the event of such damage, they must not be used until the
damage has been repaired. The toy is only to be connected to Class II equipment bearing the following
symbol.
or
ENGLISH
5 6 7
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This product has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in-
terference in a residential installation. This product generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
the product does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures :
• Reorient or relocate the receiving antenna.a
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC statement
The device contain license-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Eco-
nomic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
1. The device must not cause interference;
2. The device must accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B)
Safety instructions
A Carrera RC vehicle is a remote-controlled model car that uses special rechargeable batteries for this
A
purpose. Only original Carrera RC LiFePO
ies are to be removed from the toy before being charged.
The Carrera RC vehicle is designed for hobby use only and may only be operated on tracks and in spaces
B
especially intended for this purpose. WARNING! Do not use the Carrera RC vehicle in road traffic.
Do not operate the car beneath overhead high-voltage cables or broadcasting masts or during a storm!
C
Atmospheric disturbances can affect the operation of the vehicle. When there a large temperature
differences between your car's garage and the running track, please wait until the vehicle has had time
to acclimatise. This will help prevent conden sation forming and the possibility of malfunctions resulting.
Never operate the product on grass surfaces. There is the risk of grass hindering the movement of the
D
axles, which can lead to the motor overheating. Do not use the Carrera RC vehicle for transporting
goods, persons or animals.
Never use the Carrera RC vehicle outdoors during rain or snowfall. The car must not be run through
E
water, puddles and snow, and must always be kept stored in a dry place. Wet surfaces without puddles
will not affect the car's performance as the electronic equipment is protected against spray.
Never operate the vehicle near rivers, ponds or lakes, to avoid the risk of the Carrera RC car falling into
F
the water. Avoid running on courses which are laid exclusively with sand.
Do not expose the Carrera RC vehicle to direct sunlight. To avoid the electronics in the car overheating,
G
when temperatures are above 35 ° C, regular short pauses in operation are essential.
Never subject the Carrera car to repeated changes of load – that means continuously reversing it.
H
Always place the car on the floor by hand. Never throw the car on the floor from a standing position.
I
Avoid jumping from jumps or ramps higher than 5 cm (0.16 ft.).
K
Never use strong solvents for cleaning the car.
L
To avoid malfunctions to the control system resulting in uncontrolled operation of the Carrera RC vehicle,
M
check that the controller batteries and the rechargeable batteries in the vehicle have sufficient charge.
Supply terminals are not to be short-circuited.
The Carrera RC vehicle must be inspected before and after operation, each time it is used, to ensure
N
that it has not become disassembled. Any screws or nuts that may have become loosened during
operation must be tightened.
Instruction Manual
Contents of package
1 x Carrera RC Vehicle
1
1 x Controller
1 x USB charger cable
1 x LiFePO
rechargeable battery
4
1 x Set of batteries (non-rechargeable)
Charging the rechargeable battery
Rechargeable batteries are to be removed from the toy before being charged. Take care only to charge the
2
LiFePO
battery supplied with the LiFePO
4
recharge the battery with any other LiFePO
4
damage.
Please carefully read the previous chapter with warnings and guidelines on the usage of recharge-
able batteries before proceeding.
You can recharge the rechargeable battery with the respective USB charger
cable from a computer USB port (USB 3.0) or a USB power supply unit with at least 1A output voltage:
• Connect the USB charger cable with the USB port of a computer
lights green and indicates that the charger is correctly connected to the computer. When you connect an
empty rechargeable battery, the LED on the USB charger cable goes off and indicates that the battery is
being charged.
The USB charger cable is so designed that reversed polarity is not possible.
• It lasts about 80 minutes to recharge a discharged (NOT a deep-discharged) battery. When the battery is
fully charged, the LED display on the USB charger cable lights green again
Always recharge the battery after use to prevent its becoming deep discharged. After use, the battery
must be allowed to cool down for at least 20 minutes before it can be fully recharged. Recharge the
battery occasionally (suggested every 2–3 months). Supply terminals are not to be short-circuited.
Failure to treat the battery as described above can lead to its becoming defective. Never leave the
battery unattended while it is being charged.
Installing the rechargeable battery
Using a screwdriver, remove the cover of the battery compartment in the Carrera RC car. Connect the
3
end of the cable from the Carrera RC vehicle with the charged battery. Put the battery in place. Replace
3
recharge able batteries may be used. Rechargeable batter-
4
charging unit (USB charger cable) also supplied. If you attempt to
4
battery charger or any other type of charger, this may result in serious
. The LED on the USB charger cable

Publicidad

loading