CASO DESIGN CM 1000 Manual De Usuario página 56

21 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
21.1 Safety notices
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
21.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error
The selected program
will not start.
Food is not sufficiently
defrosted, warmed up
or cooked after preset
time has elapsed.
The device functions
but the cooking
chamber lighting does
not work.
Abnormal noises can
be heard during
operation of
microwave.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
► Clean the device before you send it to customer service.
Attention
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Incorrectly selected time or
power level
Defective cooking chamber light.
Food is covered with aluminium
foil
The cookware contains metal
and sparks are being created
within the cooking chamber
Please note
Action
Close device door
Plug in mains plug!
Activate fuse
Re-set time and power
level
Repeat process
Have Service dept repair
cooking chamber light.
Remove aluminium foil
Observe information on
cookware!
56