Publicidad
Idiomas disponibles
Idiomas disponibles
8) EXAMPLE INSTALLATION
The cables necessary for the installation of TOM can vary according to the accessories installed.
No connection cable is supplied.
Fig. 11 indicates the cables for standard installation.
List of cables
Connection
A
Mains power supply to the control unit
B
Motor connection
C
Photocell transmitter connection
D
Photocell receiver connection
E
Key selector connection for external command
F
Flashing signal light connection
G
Connection of the aerial built-in the flashing light
Legenda
1
Motoreducer
2
Photo-electric cells
3
Key selector (external) or digital keyboard
4
Flash-light
5
Electronic board
The cables used must be suitable for the type of connection. For example, for connection protected by raceways use
H03VV-F cables, for cables in the outdoor environment always use the H07RN-F type.
9) MANUAL AND EMERGENCY MANOEUVRE (FIG.12)
In the event of a power cut or breakdown, proceed as follows to operate the wings manually (refer to figures A*,B*,C,D,E):
• Rotate the protective door (fig. A*)
• After inserting the customized key C, turn it anti-clockwise (fig. B*)
• Open the protective flap of the release mechanism (Fig. C) and pull out the supplied release key (Fig. D).
• Insert the special release key supplied (fig. E) and turn it 90°, as shown in fig. F.
• It is now possible to open/close the wing manually.
• To restore automatic operation, return the release key to its initial position.
• Remove the release lever and close the protective door.
TECHNICAL DATA
Power supply
Absorbed current
Thrust
Jogging
Protection degree
Operating temperature
Capacitor
Useful stroke
Noise level
Lubrification
Opening time 90°
Mechanical stops
Encoder
Limit switch
14
TOM.30M
TOM.40M
TOM.50M
230Vac 50/60Hz
300mm
400mm
500mm
18s
24s
30s
no
si
Type
3x1,5mm
2
TOM 30M/40M/ 50M: 4x1,5mm
TOM 30E: 4x1,5mm
TOM 30ME/40ME/ 50ME: 3x1,5mm
DER)
2x1,0mm
2
4x1,0mm
2
2x1,0mm
2
2x1,5mm
2
RG 58
TOM.30ME TOM.40ME TOM.50ME TOM.3024E TOM.4024E TOM.5024E
1 A
2000 N
30%
IP44
-20°C / +50°C
9 μF
300mm
400mm
<70 dB
Permanent grease
18s
24s
Open/Close
+ 2x0,5mm
2
2
+ 3x0,5mm
2
(ENCODER)
+ 3x0,5mm
2
24 Vdc
0.7 A
1500 N
Intensive
-
500mm
300mm
400mm
30s
11s (24V)
15s (24V)
si
no
(SWO/SWC)
2
(ENCO-
2
500mm
19s (24V)
Publicidad
