cecotec BAMBA IONICARE ROCKSTAR RETRO Manual De Instrucciones página 28

ENGLISH
4. Plug the appliance into a power supply. Before plugging the appliance into the mains
socket, make sure that the speed adjustment knob is always in the off position.
5. Select the desired temperature level.
6. Select the desired speed.
7. Once you have finished using the appliance, switch it off and unplug it from the power
supply.
Warning
If you notice that the appliance switches off or stops blowing hot air, the overheating
protection has been activated. In this case, unplug it from the power supply and allow it to
cool down for a few minutes. Before switching it back on, make sure there are no fluffs, hair,
or other objects blocking the air inlet grille.
4. CLEANING AND MAINTENANCE
- Disconnect the appliance from the power supply and allow it to cool down before
cleaning.
- Use a soft, cotton cloth to clean the appliance inlets and outlets.
- Do not use sharp tools near the inlets and outlets of the appliance to avoid damage.
- Do not immerse the appliance in water or any other liquid and do not expose it to water
while cleaning it.
- Do not use abrasive scouring pads, powders, or cleaners.
- You can remove the outer grille protecting the air inlet to clean it with a cotton swab or
soft cloth. To do that:
1. Turn the outer grille counterclockwise until it unlocks.
2. Separate both parts by pulling the grille towards you. Clean the air inlet, the outer grille,
and the wire mesh.
3. Follow the reverse procedure to refit the grille.
5. TECHNICAL SPECIFICATIONS
Product reference: 04410
Product: Bamba IoniCare RockStar Retro
Power: 1700-2000 W
Voltage and frequency: 220-240 V~, 50-60 Hz
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
28
BAMBA IONICARE ROCKSTAR RETRO