Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING ( CONTINUED )
Symptom
Switch fails to operate
motor
Overheating of motor
6
EN
Possible Cause(s)
1. Switch or electrical
connections faulty
2. Motor protector activated
3. Motor damaged
1. Duty cycle too long
2. Running too long in
bypass mode
3. Strainer clogged
4. Suction pipe clogged
or damaged
Corrective Action
1. Inspect for blown fuse,
defective wiring or switch,
or improper electrical
connections. Refer to Switch
Replacement instructions in
the Repair Section
2. Turn off switch. Allow motor
to cool, then turn on switch
3. Replace pump
1. Pump operation should not
exceed the standard duty
cycle of 30 minutes ON, and
30 minutes OFF. Allow the
pump to cool for 30 minutes
2. Limit bypass operation to
10 minutes
3. Remove strainer coverplate.
Remove and clean strainer.
Install again
4. Remove pump from tank.
Inspect suction pipe. Clean or
replace, as necessary
Publicidad
