cecotec BOLERO FLUX TM 606500 INOX A Manual De Instrucciones página 10

- Important! Always disconnect the power supply during
installation and maintenance.
- The kitchen hood must be installed in accordance with
the installation instructions and in compliance with all
measurements.
- All installation work must be carried out by a competent
person or a qualified electrician.
- Dispose of the packaging material carefully. Children are
vulnerable to it.
- Pay attention to sharp edges inside the kitchen hood,
especially during installation and cleaning.
- Make sure that the duct does not have bends sharper than 90
degrees, as this will reduce the efficiency of the kitchen hood.
- Warning: failure to install the screws or fastening device
in accordance with these instructions may result in
electrical hazards
- Warning: before accessing the electrical terminals, all power
supply circuits must be disconnected.
- There must be adequate ventilation of the room when the
kitchen hood is used at the same time as gas or other fuel
burning appliances.
- Caution: the appliance and its accessible parts may become
hot during operation. Be careful not to touch any accessible
parts. Children under 8 years old must stay away, unless
they are supervised.
- Local air discharge regulations must be complied with.
- For safety reasons, only use the supplied fixing or
mounting screws (if applicable, depending on the model)
or screws of the same size as those recommended in this
instruction manual.
10 BOLERO FLUX TM 606500 INOX A / BLACK A / 906500 INOX A