cecotec BOLERO FLUX TM 606500 INOX A Manual De Instrucciones página 50

ENGLISH
5. CLEANING AND MAINTENANCE
Always switch off the power supply before cleaning or performing any maintenance work on
the kitchen hood. The cleaning and maintenance frequency depends on the use frequency and
intensity.
1. To prevent the outer surface of the kitchen hood from deteriorating over time, it is
recommended that it be cleaned with hot water and a non-corrosive detergent every two
months.
2. Do not use abrasive detergents. Otherwise, the surface of the kitchen hood may be
damaged.
3. Keep the motor and other parts away from water, as water may damage the appliance.
4. The carbon filter must not be exposed to heat.
Cleaning aluminium filters. Fig. 9
Do not use corrosive detergents to clean grease from the aluminium filters. Regular cleaning
of the aluminium filters will prolong the life of the appliance and keep it in good working order.
Follow the instructions below:
Cleaning method 1:
Immerse the aluminium filters in hot water (40-50 °C), add neutral detergent and let them
soak for 2 to 3 minutes. Protect yourself with gloves and clean the filters with a soft brush
or scouring pad. Do not apply too much force, as filters are very delicate and can be easily
damaged.
Cleaning method 2:
If you wish, you can also wash the filters in the dishwasher at a temperature of approx. 60 °C.
Carbon filter. Fig. 10
This type of filter has activated carbon and purifies air and absorbs cooking odours. The
activated carbon becomes saturated after a period of time, which will reduce the adsorption
capacity of the filter. The carbon filter cannot be washed nor cleaned in any way. When its
service life comes to an end you must replace it with a new one.
1. Remove the aluminium filters.
2. The carbon filters are located on both sides of the motor. Turn them until they are firmly
fixed.
3. To replace the carbon filter, proceed in reverse order.
50 BOLERO FLUX TM 606500 INOX A / BLACK A / 906500 INOX A