cecotec BOLERO FLUX TM 606500 INOX A Manual De Instrucciones página 49

- To facilitate air outlet, the ventilation duct should have a curvature of ≥120° and should be
connected to the outside wall.
- After installation, ensure that the kitchen hood is level to prevent grease build-up on the
end.
Figure 3 shows the necessary elements to install the kitchen hood, bracket, and hooks.
Fig. 3 key:
1. Internal chimney bracket
2. External chimney bracket
3. Wall hook
1. The kitchen hood should be placed at a distance of 65-75 cm above the cooking surface for
best effect. Fig. 4
2. Install the wall hook in a suitable location once the installation height is set and keep it
aligned. Use the screws to fix it to the wall. Fig. 5
3. Fix the outer bracket on the chimney, and make sure that the inner part of the chimney can
be adjusted to the installation height, as well as that of the flexible connection pipe. Then,
install the flexible connection pipe in the chimney of the kitchen hood and place the hood
in the bracket. Fig. 6
4. Place the kitchen hood on the hook on the wall. Fig. 7
5. Fix the outer bracket with the hooks and the inner part of the chimney with two screws
(ST4*8 mm). Fix the housing with safety screws (ST4*30 mm). Fig. 8
Note: There are two safety ventilation ducts in the back housing.
4. OPERATION
Power buttons
1. To switch on the kitchen hood, press any of the power buttons.
2. If you press the low power button, the kitchen hood will beep, and the motor will operate
at low speed.
3. If you press the medium power button, the kitchen hood will beep, and the motor will
operate at medium speed.
4. If you press the high-power button, the kitchen hood will beep, and the motor will operate
at high speed.
5. If you press the light button, both bulbs will light up. Press it again and the light will switch
off.
6. Press the off button, the motor will switch off.
BOLERO FLUX TM 606500 INOX A / BLACK A / 906500 INOX A
ENGLISH
49