Cooke & Lewis CLIND60ERF Manual Del Usuario página 5

202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.pdf, Cycle:5, Status:Approved
Caution:
• The induction hotplate must be installed by qualified personnel or technicians. Please never
conduct the operation by yourself.
• The hob must not be installed directly above a dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the hob electronics.
• Do not attempt to dismantle the appliance, there are no user servicable parts inside.
• At the end of its life, the appliance should not be disposed of in household waste; contact your
Local Authority for guidance.
• This hob must be connected to the mains power supply only by a suitably qualified person.
• Before connecting the hob to the mains power supply, check that:
1. the domestic wiring system is suitable for the power drawn by the hob.
2. the voltage corresponds to the value given in the rating plate.
3. the power supply cable sections can withstand the load specified on the rating plate.
• To connect the hob to the mains power supply, do not use adapters, reducers, or branching
devices, as they can cause overheating and fire.
• The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 75 ºC at any point.
• The work surface is square and level, and no structural members interfere with space
requirements.
• The work surface is made of a heat-resistant material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and applicable standards and
regulations.
• A suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations. The isolating switch must be of an approved type and provide a 3 mm air
gap contact separation in all poles (or in all active [phase] conductors if the local wiring rules
allow for this variation of the requirements).
• The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation.
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 4 202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 4
Printed by Henry Leung, 06/05/2021 01:52:54
Installation
Installation
Instalacja
Instalare
Installation
Installation
Instalacja
IMPORTANT
This hob can be plugged directly into a mains power outlet using the 3 pin (UK) or
2 pin (EU) plug supplied.
Follow the instructions below carefully regarding siting of the hob.
ANY CONVERSION TO A PERMANENT WIRED VERSION USING AN ISOLATION
SWITCH MUST ONLY BE CARRIED OUT BY A PROFESSIONAL INSTALLER -
SEE THE ELECTRICAL INSTALLATION SECTION LATER IN THIS MANUAL.
Instalare
Instalación
Instalação
4
28-04-2021 17:43:03 28-04-2021 17:43:03
page 5 of 108 pages