Cooke & Lewis CLIND60ERF Manual Del Usuario página 54

202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.pdf, Cycle:5, Status:Approved
03
Using the connectivity function:
1. Ensure the connectivity indicator is lit on the hob control panel.
2. The extraction rate of the hood will vary based upon the total power output selected on the hob,
as shown in the table. Each hob cooking zone has a maximum rated output of 10 comprising
1-9 and Boost (10).
Speed Level of the Hood
Speed 1
Speed 3
Speed 5
Speed P – Boost
If the hood controls are manually overridden when the hob and hood are linked, the hood will
operate for five minutes on this manual setting before returning to control by the hob.
To reconnect the hood and hob immediately, press the Timer
04
Stopping the connectivity function:
1. Touch the connectivity key
dropped. To reconnect again, press the connectivity key
2. If the hob is switched off, the hood will continue to operate independently in timer mode and the
current speed will flash.
The current speed level of the hood will continue for 5 minutes and step down for 2 minutes at each
level until finally switching off.
202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 53 202161_s1_s1_5059340093833-5059340093840_C&L_A5_IM_Multi_V04.indd 53
Printed by Henry Leung, 06/05/2021 01:52:54
Combined Power Output of the Hob
This speed will be selected when there are no more than two
cooking zones in use, and the combined output is 8 or less. For
example, zone 1 is on 2, and zone 2 is on 5.
This speed will be selected when there are no more than three
cooking zones in use, and the combined output is between 9 and
24. For example, zone 1 is on 7, zone 2 is on 6 and zone 3 is on
Boost (10).
This speed will be selected when all four cooking zones are in
use, and the combined output is between 25 and 35. For example,
zone 1 is on 7, zone 2 is on 7, zone 3 is on 9 and zone 4 is on
Boost (10).
This speed will be selected when all four cooking zones are in use,
and the combined output is greater than 35. For example, zone 1 is
on 9, zone 2 is on 9, zone 3 is on 9 and zone 4 is on Boost (10).
NOTE: Speed 2 and Speed 4 on the hood are not available when using this
function.
on the hob, the indicator light will go out and the link will be
and Light together.
on the hob again.
page 54 of 108 pages
53
28-04-2021 17:43:18 28-04-2021 17:43:18