Pump Description - Pentair PSP Serie Guia De Instalacion

General Installation Information
WARNING —Pumps improperly sized or installed or used in applications other than for which the pump was
intended can result in severe personal injury or death. These risks may include but not be limited to electric shock, fire, flooding,
suction entrapment or severe injury or property damage caused by a structural failure of the pump or other system component.
WARNING —The pump can produce high levels of suction within the suction side of the plumbing system.
These high levels of suction can pose a risk if a person comes within the close proximity of the suction openings. A person can
be seriously injured by this high level of vacuum or may become trapped and drown. It is absolutely critical that the suction
plumbing be installed in accordance with the latest national and local codes for swimming pools.
• These instructions contain information for a variety of pump models and therefore some instructions may not apply to a
specific model. All models are intended for use in swimming pool applications. The pump will function correctly only if it is
properly sized to the specific application and properly installed.
• The pump is available with or without a specially designed strainer pot assembly. Pumps without the strainer pot assembly
are not self-priming and must be installed so that the pump is always flooded with water. If the pump is to be installed
without a strainer pot, plumbing suction inlets must prevent debris larger than ¼ in. in diameter from being drawn into the
pump.
• Pumps installed with the specially designed strainer pot assembly are self-priming at heights up to 3 meters depending on
the specific installation.
• Pump should be used only in the specified operating conditions.
• Do not run the pump in the wrong direction of rotation.
• Do not step on the pump and/or piping connected to the pump.
• Do not insert hands or fingers into the pump openings or holes.
• Any weight, stress or strains on the piping system should not be transmitted to the pump.
• Any work executed on the pump should be carried out by at least 2 authorized persons.
Pump pre-filter and suction line must be completely filled with liquid.

Pump description

PENTAIR Thermoplastic Centrifugal Pumps are self priming, single stage, close-coupled (Pump with built-in electric motor, with
the motor drive and pump impeller on the same shaft), monoblock centrifugal pumps with closed impeller and mechanical
seals. These pumps are suitable for non-aggressive, non-explosive, clean or slightly contaminated liquids with low viscosity and
specially designed for the pre-filtering and re-circulation of water in swimming pools, fish farming and other general purposes.
ATTENTION
The pump should be used only in the operating conditions given on the order for which the pump and materials of the con-
struction have been selected and tested. Sales office and representative of the manufacturer refuse to assume any responsibility
if the pump is used for different applications without prior written permission.
General Technical Data
Speed
Suction and discharge
Operating Temperature
Ambient Temperature (max)
Casing Pressure (max)
Insulation Class
Enclosure Rating
Electrical Connection
G-INSB-PSP (REV 02/2013)
ATTENTION
Do not operate the pump without water.
: 2850 RPM
: DIN 8063 / PN 10
: 5°C up to 50°C
: 40°C
: 2.5 BAR
: F
: IP 54
: 50Hz - 3ph - 380V
4