YATO YT-828293 Manual Original página 15

TOOL DESCRIPTION
The angle grinder is a power tool designed for grinding and cutting metals and mineral building materials such as brick, natural
and artifi cial stone, concrete, glazing, etc. using abrasive discs and grinding wheels selected for a given material. Under no
circumstances must the tool be used for processing materials other than those mentioned above, e.g. for grinding and cutting
wood or polishing. The correct, reliable and safe operation of the grinder requires its proper use, so before using the grinder:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
Always use an eye guard!
Do not use grinding discs with a maximum permissible perimeter speed of less than 80 m/s!
Do not use grinding wheels with a maximum permissible rotational speed lower than the grinder's speed.
The supplier is not liable for any damage resulting from failure to observe the safety instructions and recommendations contained
in this manual.
EQUIPMENT
The tool is delivered complete but requires preparation before starting work. The product is supplied with a battery pack, a
charging station (charger), an abrasive disc guard, a wrench for fi xing the grinding disc and an additional handle. The equipment
does not include abrasive discs. The YT-828293 product does not have a battery pack and a charging station.
TECHNICAL DATA
Parameter
Part no.
Mains voltage
Rated rpm
Diameter of the abrasive disc
Diameter of the abrasive disc hole
Spindle taper
Weight
Noise level
- sound pressure L ± K
pA pA
- power L ± K
wA wA
Vibration level ± K (main/additional handle)
ah,AG
Insulation class
Protection rating
Battery type
Battery capacity
Charger*
Input voltage
Mains frequency
Output voltage
Output current
Rated power
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use
(including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be specifi ed.
O R I G I N A L
EN
Unit
[V]
[min ]
-1
[mm]
[mm]
[kg]
[dB (A)]
[dB (A)]
[m/s ]
2
[Ah]
[V]
[Hz]
[V]
[A]
[W]
[h]
I N S T R U C T I O N S
Value
YT-828293, YT-828294, YT-828295
18 DC
3000 – 8500
125
22.2
M14
1.26
89.0 ± 3.0
97.0 ± 3.0
7.28 ± 1.5
III
IPX0
Li-Ion
4
220 – 240
50/60
21 DC
2.4
60
2
15