YATO YT-828293 Manual Original página 22

EN
When grinding with the side surface, keep the grinder at an angle of not more than 30 degrees from the surface to be worked on
(VII). Move the grinder smoothly to and from yourself.
When cutting, the disc should be at a right angle to the cut surface. Do not cut at a diff erent angle. It is forbidden to change the
angle of the cutting disc to the workpiece while cutting. Cut only in a straight line. Failure to follow the above recommendations
increases the risk of jamming the cutting disc in the workpiece, which can cause the tool to bounce towards the operator, break
the disc or fall apart.
When cutting, guide the grinder towards the rotation of the disc (VIII).
When working with the grinder, do not exert too much pressure on the workpiece and do not make sudden movements in order
not to cause jamming or cracking and tearing of the abrasive disc.
Do not overload the tool, the temperature of the external surface must never exceed 60°C.
After fi nishing work, turn off the grinder, remove the battery and inspect it.
Caution! The disc may be still spinning for some time after turning the grinder off . Wait for the disc to cool down before starting the
inspection. During operation, both the disc and the material to be processed can become heated to high temperatures.
Remember! When operating with an angle grinder:
Always use an eye guard.
Do not use abrasive discs with a maximum permissible circumferential speed of less than 80 m/s.
Do not use abrasive discs with a maximum permissible rotational speed of less than the grinder's rotational speed.
MAINTENANCE AND INSPECTIONS
CAUTION! Before starting adjustment, maintenance or servicing, pull the tool plug out of the mains socket or disconnect the
battery from the tool. Having fi nished working, inspect the power tool for damage by visually checking the exterior and the body
and the handles. Check the power cord with plug and its rubber gland or the battery housing, the action of the electric power
switch, the ventilation openings for clogging, the motor brushes for sparking, the noise of the bearings and the drive transmission,
and how the power tool starts and runs. During the warranty period, the user is not allowed to install any power tools or replace any
components or parts, as this will void the warranty rights. Any irregularities found during the inspection or the operation signal the
need for repair to be done at the service centre. After fi nishing work, the housing, ventilation openings, switches, auxiliary handle
and covers should be cleaned e.g. with an air jet (with a pressure not exceeding 0.3 MPa), paintbrush or dry cloth without the use
of chemicals and cleaning agents. Clean the tools and the handles with a clean dry cloth.
O R I G I N A L I N S T R U C T I O N S
22