Use; Before Machine Start-Up - Nilfisk-Advance Micromatic 13 Instrucciones De Uso

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
–
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

14
9
Brush installation
NOTE
The machine is supplied with two brushes (A, Fig. 2) installed. According to the type of floor to be cleaned, it is possible
to replace the brushes (A) with the pad-holders with pads (B).
Lift the machine by prying the handlebar (2).
1.
Install the brushes (A, Fig. 2) in the 2 hubs of the deck (9).
2.
Lower the machine by using the handlebar (2).
3.
10
INSTRUCTIONS FOR USE
18
A
9097508000(1)2008-03
3
9
A
Figure 2
Micromatic™ 13E
2
P100166A
P100168