Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - Nilfisk-Advance Micromatic 13 Instrucciones De Uso

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
Thank you for choosing an Advance scrubber-dryer.
Advance scrubber-dryer Micromatic™ 13E is an efficient and superior quality machine for floor cleaning.
The machine is equipped with two turning brushes for a cleaning width of 12.9 in (330 mm).
Front and rear squeegees clean out the floor, while a vacuum system collects the dirty water, all in one wipe.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualified technicians must read this Manual carefully. Contact
Advance in case of doubts concerning the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualified to perform the machine maintenance.
The operators must not perform procedures reserved for qualified technicians. Advance will not be responsible for damages coming
from the non-observance of this prohibition.

HOW TO KEEP THIS MANUAL

The Instructions for Use Manual must be kept near the machine, inside an adequate case, away from liquids and other substances
that can cause damage to it.

IDENTIFICATION DATA

The machine model and serial number are marked on the plate (1).
The machine production year is indicated by the first two figures of the machine serial number.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identification data.
MACHINE model ...............................................................................
MACHINE serial number ...................................................................

OTHER REFERENCE MANUALS

Spare Parts List (supplied with the machine)
–
Service Manual (that can be consulted at Advance Service Centers)
–

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be performed by qualified personnel or by Advance Service
Centers. Only original spare parts and accessories must be used.
Contact Advance for service or to order spare parts and accessories, specifying the machine model and serial number.

CHANGES AND IMPROVEMENTS

Advance constantly improves its products and reserves the right to make changes and improvements at its discretion without being
obliged to apply such benefits to the machines that were previously sold.
Any change and/or addition of accessory must be approved and performed by Advance.

OPERATION CAPABILITIES

These scrubber-dryers are used to clean (scrubbing and drying) smooth and solid floors, in civil or industrial environment, under
safe operation conditions by a qualified operator.

CONVENTIONS

Forward and backward, front and rear, left and right references are intended with the operator in driving position with the hands on
the handlebar (2).
2
INSTRUCTIONS FOR USE
9097508000(1)2008-03 Micromatic™ 13E