Descargar Imprimir esta página

GE Quick Set V Manual Del Propietário página 40

Cocinas electricas independientes, empotrables y encastrables
Ocultar thumbs Ver también para Quick Set V:

Publicidad

Idiomas disponibles

Idiomas disponibles

Care and cleaning of the range.
I
I SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect
-&WARNING, the electrical
power tothe range atthe main f use o rcircuit breaker
panel
Failure to do so may result in electric shock or burn.
CAUTION
Receotacle
Socket
I BURN HAZARD: The glass cover and bulb should be removed when cool.
Touching hot glass with bare hands or a damp cloth can cause burns.
Oven Light Replacement
(on some models)
To remove:
IT1 Turn the gloss cover counterclockwise
1/4 turn until the tabs of the glass
cover clear the grooves of the socket.
Wearing latex gloves may offer
o better grip.
G6.35Bulb
I_
Using gloves or a dru cloth, remove
the bulb by pulling it straight out.
/
Glass cover
(onsomemodels)
i
To replace:
[Z]
Use o new 120/130-volt halogen bulb,
not to exceed 50 watts. Replacethe
bulb with the some type of bulb that
was removed. Your model will hove
one of the two types shown on
the left. To determine the correct
replacement bulb, check the bulb
terminals. Bulbswith 2 straight pin
terminals ore G6.35bulbs. Bulbs
with 2 looped terminals ore G9 bulbs.
(Do not interchange.}Be sure the
replacement bulb is rated 120 volts
or 130 volts (NOT12 volts).
[]
Using gloves or o dru cloth, remove
the bulb from its packaging. Do not
touch the bulb with bore fingers. Oil
from skin will damage the bulb and
shorten its life.
%
Pushthe bulb straight into the
receptacle oil the wou.
Placethe tabs of the gloss cover into
the grooves of the socket. Turn the
gloss cover clockwise 1/4 turn.
For improved lighting inside the oven,
cleon the gloss cover frequently using
o wet cloth. This should be done when
the oven is completely cool.
I_] Reconnect electrical power to
the oven.
Glasscover
(onsomemodels)
%
/
Wire cover holder
40
Oven Light Replacement
(on some models)
Be sure to let the light cover and bulb cool
completelu.
To remove the cover:
%
Hold o hand under the cover so
it doesn't foil when released.With
fingers of the same hand, firmlu push
back the wire cover holder.Lift off the
cover.
Do not remove ang screws to remove
the cover.
Toreplace the cover:
%
Place it into groove of the light
receptacle. Pullwire forward to the
center of the cover until it snaps into
place.
I_
Connect electrical power to the range.
[_
Replacebulb with o 40-watt
appliance bulb.

Publicidad

loading

Este manual también es adecuado para:

Quick set viNext step control