Sub-Zero Designer Serie Guia De Instalacion página 17

Installation
Completion
TOP TRIM INSTALLATION
Identify the top trim strips by the notch on one end at the
bottom; this trim strip fits on the hinge side of the unit.
Insert the outer end of each trim strip behind the vertical
side trim. Engage the snap in the plastic side bracket and
slide the panel as far to the outside as possible. Refer to the
illustration below.
Rotate the inner end of each panel into the side flange
of the center shroud next to the water filter access door.
Press on the trim strip to snap into place. Refer to the illus-
tration below.
Inner top trim Outer top trim
KICKPLATE INSTALLATION
Position the kickplate and install using the two mounting
screws. Refer to the illustration below. The kickplate must
be removable for service. The floor cannot interfere with
removal.
For indoor models, a maximum 6"
can be attached to the factory-installed kickplate. The two
rows of vented louvers can be covered if the door panel
is a minimum 4" from the finished floor. A decorative
(102)
kickplate cannot be attached to the outdoor model.
To install a decorative kickplate, remove the paper backing
from the magnets and attach the decorative kickplate to
the magnets. The magnets allow the decorative kickplate
to be removed if necessary.
Turn power on by touching "power" on the control panel.
MAGNET SCREW
Kickplate installation
decorative kickplate
(152)
subzero.com | 17