Publicidad
Idiomas disponibles
Idiomas disponibles
Use
to select the rate in V/s (100 to 9900 V/s in 100 V steps) and
press
to confirm. After the parameters are configured, set the ramp
down according to the following instructions.
Ramp down
9.3.5.
• Use the control
Use
to select the rate in V/s (100 to 9900 V/s in 100 V steps) and
press
to confirm. After all parameters have been set, exit the MENU
and start the test by pressing
Ramp test result
9.3.6.
During the ramp test, the HP80KV displays the total test time and the
application duration time of the configured maximum voltage.
After the end of the test, regardless of the result, the display will report
intermittently the time mentioned above.
, to select RAMP DOWN and press
.
28
.
Publicidad
