Publicidad
Idiomas disponibles
Idiomas disponibles
13. Cleaning
Before cleaning the equipment, disconnect the equipment from the mains
and disconnect all cables.
The panel, terminals and connectors of the equipment must stay dry and
clean. Cleaning should be made using a wet cloth in water and a soft
detergent or isopropyl alcohol (be sure that the products to be used for
cleaning does not affect plastic goods).
After cleaning and before plugging in again, make sure that the
equipment is completely dry to avoid risk of electric shock and
malfunction of the hipot.
14. Maintenance
Before each use, check the equipment for visible damage to the
enclosure, panel, cables, and accessories. If any malfunction or damage
is found that could compromise the safety of the equipment, do not use
the hipot and contact the service center. Do not use the equipment if the
power cord or any other cable (interconnect or accessory) is damaged
and contact service.
Fuse: the control unit has a fuse in the power input. To replace the fuse:
1.
Disconnect the equipment from the power supply and disconnect
the cables from the control unit;
2.
Use a screwdriver to open (¼ turn) the fuse compartment;
3.
Replace the fuse with an equivalent, as indicated in the product's
specifications.
4.
Completely close the fuse compartment (¼ turn) using a
screwdriver.
Fuse Schurter, model SPT 5x20 (Time-lag) 8A/250V.
Disconnect the power cord from the equipment before accessing
the fuse holder.
To replace the fuse, use only the fuse type specified in the
equipment.
High breaking capacity.
35
80KV
HP
Publicidad
