Introduction; Technical Specifications - SPX LeakTamer Plus Evap Manual Del Operador

Introduction

Congratulations!
You are in possession of the most useful, yet simple to operate, Evaporative
Emissions (EVAP) system diagnostic tester available today. The LeakTamer
Plus's versatile 12-volt design was specifically developed to diagnose vehicle
EVAP systems for leaks.
In addition, the LeakTamer Plus will also find intake manifold system leaks,
exhaust system leaks, and under-dash vacuum system leaks. It will also diagnose
many other closed systems where you may suspect a leak, as well as pinpointing
wind and water leaks entering the vehicle's passenger compartment.
The LeakTamer Plus's unique design allows the operator to confirm the integrity
of a system by utilizing a metered air system. If the tool has confirmed a leak in
the system being tested, it then introduces a non-toxic, diagnostic, marked vapor
(smoke) into the system. To locate the source of the leak, you simply look for the
smoke exiting the leak, or use a conventional ultraviolet (UV) lamp to view the
UV deposit left behind, which pinpoints the exact location of the leak.
The LeakTamer Plus is shipped filled with a full charge of smoke-producing
solution that will last approximately 500 tests.
Height 23 in. (58.4 cm)
Width 18 in. (45.7)
Depth 9 in. (24.1 cm)
Weight 17 lbs. (7.6 kg)
Ship Weight 20 lb. (9.0 kg)
Power Supply 12V DC
Amperage Usage 15 amps
4

Technical Specifications

Supply Pressure
Supply Volume
Operating Temperature Range 45°F to 140°F (7.2°C to 60°C)
Supply Line
Power Supply Line
Remote Starter Cable
13.0 in. H O
2
15 liters per minute
10 feet (3.0 m)
10 feet (3.0 m)
10 feet (3.0 m)