Publicidad
Finally, fix the bars (8) to the pulley frame (1) and to the
lower tube (3) using the screws (24), the washers (32) and
the nuts (30), Fig.5.
6.- Attach the pulleys (20) and the cable (18) to the upper
frame using the screws (24), the washers (32) and the nuts
(30), Fig.6.
Attach the end of the cable (18) to the selector bar (34).
Attach the pulleys (20) to the pulley brackets (16) using the
screws (23), the washers (32) and the nuts (30), Fig.6.
Pass the cable (18) through the upper pulley of the bracket
(16), and then attach the cable (18) and the pulley (20) to
the end of the upper frame using the screw (24), the
washers (32), and the nut (30), Fig.6.
Pass the cable (19) through the lower pulley of the bracket
(16) and fix the end to the lower tube (3) using the screw
(23), the washers (32) and the nut (30), Fig.6. Place the
pulley (20) and the cable (19) in the lower bracket.
Attach the accessory (6) on the cable (18) and the
accessory (7) on the cable (19), Fig.6.
7.- Remove the nuts and washers (C) from the top of the
vertical tubes, Fig.7.
Attach the left upright tube (9) ti the upper frame and refit
the previously removed nut and washer (C). Fix it to the
lower frame using the screw (25), the washers (33) and the
nut (31), Fig.7.
Follow the same process to assemble the right upright tube
(10).
Place the supports (11) on the columns (9) and (10) using
the screws (27) and the washers (33), Fig.7.
Do not hesitate to get touch with the Technical Assistance
Service if you have any queries by phoning customer
services (see last page in manual).
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE.
16
Publicidad
