Publicidad
Idiomas disponibles
Idiomas disponibles
Hot
Thread
Protector
2. Install the Valve - Ceiling Installations
IMPORTANT! Perform these steps for ceiling installations only.
Remove the aspirator with a 3/8" hex wrench.
Turn the yoke over so that the supplies connect from the top of
yoke.
Reinstall the aspirator at the top of yoke. Do not overtighten.
NOTE: Reversing the yoke will reverse the direction the lever
handles close. For proper lever handle operation, reverse the valve
units.
Before removing the valves, make sure they are in the open
position (cold = fully clockwise, hot = fully counterclockwise).
Remove the thread protectors and reverse the valves.
Wrench tighten the valves.
Replace the thread protectors.
106966-2-AD
Ceiling
Supplies
Aspirator
Cold
Valve Unit
4
Kohler Co.
Publicidad
