Publicidad
Idiomas disponibles
Idiomas disponibles
TABLE OF CONTENTS
USE AND CARE GUIDE & CONTACT INFORMATION.................................................. 1
TABLE OF CONTENTS & WARNING & ADDITIONAL SAFETY INSTRUCTIONS ....... 2
ADDITIONAL SAFETY INSTRUCTIONS & WARRANTY................................................. 3
ENERGY EFFICIENT USE OF CEILING FANS &
ELECTRICAL AND STRUCTURAL REQUIREMENTS.................................................... 4
ELECTRICAL AND STRUCTURAL REQUIREMENTS(CONTINUED)............................. 5
PRE-INSTALLATION & MATERIALS NEEDED................................................................ 6
UNPACKING INSTRUCTIONS.......................................................................................... 7
HOW TO HANG YOUR CEILING FAN.............................................................................. 8
WARNING
READ AND SAVE THESE INSTRUCTIONS
To avoid fire, shock and serious personal injury, follow these instructions
1. Read your owner's manual and safety information before installing your new fan. Review the accompanying assembly diagrams.
2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from
being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag,
to the service panel.
3. Be careful of the fan and blades when cleaning, painting, or working near the fan. Always turn off the power to the ceiling fan before
servicing.
4. Do not insert anything into the fan blades while the fan is operating.
5. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to
ensure that they do not play with the appliance.
ADDITIONAL SAFETY INSTRUCTIONS
To avoid possible shock, be sure Turn off the power at
the fuse box before wiring, and do not operate fan
without blades.
All wiring and installation procedures must satisfy
National Electrical Codes (ANSI/ NFPA 70) and Local
Codes.
The ceiling fan must be grounded as a precaution
against possible electrical shock.
Electrical installation should be made or approved by a
licensed electrician.
The fan box must be securely mounted and capable of
reliably supporting at least 35 lbs. (fan and accessories
not to exceed 35 lbs. or 15.9 kgs.).
See page 5 of owner's manual for support requirements.
Consult a qualified electrician if in doubt.
The fan must be mounted with the fan blades at least 10
feet from the floor to prevent accidental contact with the
ceiling fan.
Follow the recommended instructions for the proper
method of wiring your ceiling fan. If you do not have
adequate electrical knowledge or experience, have your
fan installed by licensed electrician.
Suitable for use with solid-state speed controls.
This fan can be used indoors or outdoor and is approved
for damp location.
For supply connections, if the conductor of a fan is
identified as a grounded conductor, then it should be
connected to a grounded conductor power supply. If the
conductor of a fan is identified as an ungrounded
conductor, then it should be connected to an unground-
ed conductor power supply. If the conductor of a fan is
identified for equipment grounding, then it should be
connected to an equipment-grounding conductor.
WIRE THE CEILING FAN & WIRING YOUR CEILING FAN.....9
WIRING YOUR CEILING FAN (CONTINUED) &
HOW TO INSTALL YOUR CANOPY HOUSING ......................10
HOW TO OPERATE YOUR CEILING FAN ..............................11
HOW TO OPERATE YOUR CEILING FAN (CONTINUED) .....12
HOW TO OPERATE YOUR CEILING FAN (CONTINUED) &
MAINTENANCE ........................................................................13
TROUBLESHOOTING ..............................................................14
REPLACEMENT AND DISASSEMBLY DIAGRAM OF FAN
BLADES ....................................................................................15
EXPLODED REVIEW ILLUSTRATION .....................................16
CAUTION: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
WARNING: To reduce the risk of electric shock, this fan must
be installed with a general use, isolating wall.
This product is designed to use only those parts supplied with
this product and/or accessories designated specifically for
use with this product. Using parts and/or accessories not
designated for use with this product could result in personal
injury or property damage.
To reduce the risk of personal injury, do not bend the blade
bracket (flange or blade holder) when installing the brackets,
balancing the blades, or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
Mount to an outlet box marked acceptable for fan support of
15.9 kg (35 lbs) or Less.
2
Publicidad
