Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO INSTALL YOUR FAN BLADE
pull out the hairpin. (Figure 1)
Align the U-slot of the fan blade with
the locating pin of the motor rotating
shaft. The pin should sink into the U-
slot of the fan, then insert the hairpin
into the side hole of the motor
rotating shaft and clamp it on the
motor rotating shaft. Finally, screw
the fan nut cover into the middle
shaft of the motor and tighten it
counterclockwise to fix the fan
blade. (Figure 2)
HOW TO OPERATE YOUR CEILING FAN
IMPORTANT: Using a full range dimmer switch
to control fan speed will damage the fan. To reduce the
risk of fire or electrical shock, do not use a full range
dimmer switch to control the fan speed.
(Figure 1)
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING:
Check all connections are tight, including
ground, and that no bare wire is visible at
the wire connectors except for the ground
wire. Do not operate fan until the blades
are in place.
WARNING:
Do not operate this fan with a variable
(Rheostat) wall controller or dimmer switch.
Doing so could result in damage to the
ceiling fan.
Check all connections are tight, including ground,
and that no bare wire is visible at the wire
connectors except for the ground wire.
Do not operate fan until the blades are in place.
(Figure 3)
WARNING
To reduce the risk of fire or electrical shock,
this fan should only be used with fan speed
control part No.: QH-0019UL
Fan blade
Fan nut cover
Figure 1
11
Hairpin Clip
Clamping
Fan nut cover
For illustrative purposes only
1.5V/AAA
battery (2)
Battery box
back cover
Install the
locating pin
into the U-slot
of the fan
blade
screwdriver
(not furnished)
Figure 2
MAIN FUSE BOX
Publicidad
