Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING YOUR CEILING FAN (CONTINUED)
WARNING:
Check to see that all connections are tight,
including ground, and that no bare wire is
visible at the wire connectors except for the
ground wire. Do not operate fan until the
blades are in place. Noise and motor
damage could result.
After connections have been made, the wires should be spread
apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the ungrounded
conductor on the other side of outlet box, then turn leads upward
and carefully push leads into the outlet box, with the white and
green leads to one side of the box and the
black leads to the other side. (Figure 4)
HOW TO INSTALL YOUR CANOPY HOUSING
NOTE:
This step is applicable after the neccessary
wiring is completed.
First screw the key hole of the ceiling canopy into the two
screws of the hanger bracket.
Align the canopy hole with the screw hole of the hanger,
Install using the 2 screws previously removed and lock in 4
screws to fix the canopy, taking care not to pinch the wires.
Tighten screw.
Securely attach and tighten the canopy screw cover over
the shoulder screws in the Ceiling Canopy utilizing the key
slot twist-lock feature. (Figure 1)
WARNING:
To avoid possible fire or shock, make sure
that the electrical wires are completely
inside the canopy housing and not pinched
between the housing and the ceiling.
Hanger
Bracket
Screw (2)
Screw (4)
locking
10
Screw (2)
Previously
removed screws
Publicidad
