Installing Guide Bar And Saw Chain - STERWINS PCS 46 Manual De Instrucciones

INSTALLING GUIDE BAR AND SAW CHAIN

A standard saw unit package contains the items as illustrated, (F1)
(1) Power unit
(2) Bar protector
(3) Guide bar
(4) Saw chain
(5) Plug wrench
(6) Screwdriver for carburetor adjustment
Open the box and install the guide bar and the saw chain on the power unit as follows:
The saw chain has very sharp edges. Use thick protective gloves for safety.
1.Pull the guard towards the front handle to
check that the chain brake is not on.
2.Loosen the nuts and remove the chain
cover. (remove the adjustment cover)
3.Gear the chain to the sprocket and, while
fitting the saw chain around the guide bar,
mount the guide bar to the power unit.
Adjust the position of chain tensioner nut on
the chain cover to the lower hole of guide
bar. (F2)
(7) Hole
(8) Tensioner nut
(9) Chain cover
F1
(1)
(2)
(3)
(4)
32
(5)
(6)
F2
(9)
(7)
(8)