STERWINS PCS 46 Manual De Instrucciones página 33

NOTE
Pay attention to the correct direction of the saw chain.
(F3)
(1) Moving Direction
4.Fit the chain cover to the power unit and fasten the nuts to finger tightness.
5.While holding up the tip of the bar, adjust the chain tension by turning the tensioner screw
until the tie straps just touch the bottom side of the
bar rail. (F4)
6.Tighten the nuts securely with the bar tip held up
(12-15N.m). Then check the chain for smooth rotation
and proper tension while moving it by hand. If
necessary, readjust with the chain cover loose.
(2) Loosen
(3) Tighten
(4) Tensioner screw
NOTE
A new chain will expand its length in the beginning of use. Check and readjust the tension
frequently as a loose chain can easily derail or cause rapid wear of itself and the guide bar.
F3
F4
33
(3)
(4)