Descargar Imprimir esta página

Husqvarna 135R Manual De Usuario página 19

Ocultar thumbs Ver también para 135R:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 162
Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
cable from the spark plug before you
assemble the product.
To assemble the throttle handle
1. Remove the screw behind the throttle handle. (Fig.
32)
2. Move the throttle handle to the right side of the
handlebar.
3. Align the hole behind the throttle handle with the
hole in the handlebar.
4. Put the screw through the holes. Tighten the screw.
To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration. (Fig. 33)
2. Tighten the knob lightly.
3. Put on the harness and hang the product from the
suspension point.
4. Adjust the handle to put the product in a good work
position. (Fig. 34)
5. Tighten the knob fully.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B). (Fig. 35)
3. Carefully push the shaft into the coupling until you
hear a click. (Fig. 36)
4. Tighten the knob fully. (Fig. 37)
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling. (Fig. 38)
2. Push and hold the button (C).
3. Hold tight to the end of the shaft that the engine is
attached to.
4. Pull the attachment straight out of the coupling. (Fig.
39)
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
975 - 010 - 11.09.2023
Assembly
Before you assemble the
Remove the spark plug
WARNING:
WARNING:
attachment guard that is recommended for
the cutting attachment. See
page 29 .
WARNING:
cutting attachment can result in injury or
death.
To attach the guard extension
CAUTION:
when you use a trimmer head/plastic blade.
Do not use the guard extension when you
use a grass blade.
1. Put the guard extension in the groove of the cutting
attachment guard. (Fig. 40)
2. Put the guard extension into position on the cutting
attachment guard with the 4 locking hooks.
To remove the guard extension
Release the locking hooks with the spark plug
wrench. (Fig. 41)
To attach the grass blade and the grass blade
guard/combination guard
1. Put the blade guard/combination guard (A) onto the
shaft and tighten the bolt to attach it. (Fig. 42)
2. Make sure that the guard extension is removed.
3. Turn the output shaft to align one of the holes in
the drive disc (B) with the related hole in the gear
housing.
4. Put the locking pin (C) in the hole to lock the shaft.
5. Put the grass blade (D), the support flange (F) and
the support cup (E) on the output shaft. (Fig. 43)
6. Make sure that the drive disc and support flange
engages correctly in the centre hole of the grass
blade. (Fig. 44)
7. Attach the nut (G).
8. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm. (Fig. 45)
Use protective gloves.
Always use the cutting
Accessories on
An incorrectly attached
Use the guard extension
19

Publicidad

loading

Este manual también es adecuado para:

336fr336rk