Sony KP-41T35 Manual De Instrucciones página 36

MDP manufacturer code numbers
Operating video equipment
Manufacturer Code number
Sony 701
Kenwood 707 VTR (POWER)
Magnavox 703
Maranz 702
Mitsubishi ~ 702 VTR (FUNCTION)
Panasonic
704
Video operating
Philips 703 a
Pioneer 70200=«O
eas ts 0 - 9 buttons
Sharp ; 705
Yamaha
703
ENTER
Notes
* If more than one code number is listed, try entering them one
by one, until you come to the correct code for your equipment. CH +/-
* In some rare cases, you may not be able to operate your non-
36N
Sony video equipment with the supplied remote control. This
is because your equipment may use a code that is not included
with this remote control. In this case, please use the
equipment's own remote control unit.
The code numbers for Sony equipment are assigned at the
factory as follows:
VHS VCR 301 (preset code for the supplied
remote control)
8mm VCR 302
Beta, ED Beta VCRs 303
Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code number may
revert to the factory setting and must be reset.
Use the video operating buttons on the remote
control to operate the video equipment.
Press VTR (FUNCTION) before operating the
video equipment.
Operating a VCR
Buttons on the remote control
To turn on or off
To select a channel
directly
To change channels
To record
Press VTR (POWER).
Press the 0 - 9 buttons.
Press CH +/-.
Press B while pressing @. First release
B-, then release @.
To play Press >.
: = To stop Press @.
To fast forward Press D>.
To rewind the tape Press <4.
To pause Press #1.
Operations
To search the picture
forward or backward
To resume normal playback, press again.
Press B® or 4 during playback.
To resume normal playback, release the
button.
To change input mode
Operating an MDP
Press TV/VTR.
Buttons on the remote control
To turn on or off Press VTR (POWER).
To play Press >.
Tostop.-... ~ Press Mf. we
To pause Press Uf.
To resume normal playback, press again.
Fo search the picture
forward or backward
Keep pressing > or <4 during
playback.
To resume normal playback, release the
button.
To search the chapter
forward and backward
Note
Press CH +/-.
¢ If the video equipment does not have a certain function, the
corresponding button on this remote control will not operate.