Metabo BS 12 NiCd Manual Original página 10

ENGLISH
ENG
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
Secure the workpiece against slipping, e.g. with the
help of clamping devices.
LED (7): Do not view LEDs directly through optical
instruments, LED class 1M, classified as per
DIN EN 60825-1: 2003, wavelength: 400-780 nm;
5 lm.
5 Overview
See page 3 (please unfold).
1 Keyless chuck
2 Selector barrel (torque, drilling)
3 Switch (1st/2nd gear)
4 Rotation selector switch (rotation setting,
transport lock) - both sides of the machine
5 Battery pack release button
6 Battery pack
7 LED lights
8 Trigger
6 Use
6.1 Battery pack
Charge the battery pack before use.
The battery pack reaches its full capacity only after
being charged and discharged 5 times (charge
cycles).
The maximum number of charge cycles can only
reached if an exhaustive discharge of the battery
pack is avoided. If performance diminishes,
recharge the battery pack.
6.2 Removing and inserting the battery
pack
Removal:
Press the battery pack release (5) button and pull
the battery pack (6) forwards.
Inserting:
Slide in the battery pack (6) until it engages.
10
6.3 Setting the direction of rotation,
engaging the transporting safety device
(switch-on lock)
Set the rotation selector switch (4).
See page 3 (please unfold).
R = Clockwise setting
L = Counter-clockwise setting
0 = Central position: transport lock setting
(switch-on lock)
6.4 Selecting gear stage
Do not set the switch (3) unless the motor
has stopped completely!
Actuate the switch (3).
1st gear setting (low speed), very high torque
2nd gear setting (high speed)
6.5 Setting the torque limit
Turn the sleeve (2).
1... = Torque setting (for working with torque
control)
= Drill setting - no torque control
(for max. torque)
6.6 On/Off switch, setting the speed
Switching on, speed: press the trigger (8). Press
in the trigger to increase the rotational speed.
Switching off: Release the trigger (8). Note: The
noise that the machine makes when it
switches off is due to the design (quick stop)
and has no influence on the function or the
service life of the machine.
6.7 LED lights
For working on dimly lit areas. The LED lights (7)
light up when the machine is switched on.
6.8 Keyless chuck
1
GRIP, ZU
AUF, RELEASE