Metabo BS 12 NiCd Manual Original página 11

Opening the chuck
Turn sleeve (1) in the direction "AUF,
RELEASE".
Clamping the tool
- Open the keyless chuck and insert the tool as far
as possible.
- Turn the sleeve (1) in the direction of "GRIP, ZU"
until the tool is clamped securely.
- With a soft tool shank, retightening may be
required after a short period of operation.
Unscrewing the chuck
a b
- Open the keyless chuck.
- Slacken the screw (a) (note: left-handed thread!).
- Unscrew the keyless chuck (1) using a spanner
(b).
Employ the same procedure when attaching the
chuck, except in reverse order.
Cleaning
From time to time, hold the machine vertically with
the chuck facing downwards and turn the sleeve
fully in the direction "GRIP, ZU" and then turn fully
in the direction "AUF, RELEASE". The dust
collected falls from the keyless chuck.
7 Tips and Tricks
Drilling
- Preferably in 2nd gear (high speed).
- In the case of deep bores, pull the drill bit out of
the bore from time to time in order to remove the
drill dust or swarf.
Screws
- Preferably in 1st gear (low speed) and with
torque control.
Thread tapping
- Lubricate the dies.
- Select 1st gear (low speed).
- Adjust torque control.
8 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
1
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Chargers
B Battery packs with different capacities.
Use battery packs only with voltage suitable for
your power tool.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
9 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
10 Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Battery packs must not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact
with water!
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.
11 Technical Specifications
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
U = Voltage of battery pack
n = No-load speed
0
ENGLISH
ENG
11