Hilti Nuron CU 4-22 Manual De Instrucciones página 22

5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on / off
1. To switch the product on, short-press the ON⁄OFF button or LED ON⁄OFF button.
2. To switch the product off, long-press the ON⁄OFF button for 1.5 seconds.
The product automatically switches off after 5 minutes without use.
6.2 Charging device via USB port
▶ Connect the charging cable of your device to the port of the USB charging adapter.
In cold dry weather, the electrostatic discharge (ESD) protection function might be triggered to
protect the product by switching the product off. To restore normal operation, remove and then
reinsert the battery.
6.3 Charging device wirelessly
▶ Place the device in the center of the wireless charging pad. Check state of charge of the device.
The product has a built-in thermal management function and will dynamically adjust output
performance to suit thermal conditions.
The wireless charging function will be deactivated automatically after 5 minutes without any
wireless device connected. To reactivate the wireless charging function, short-press the ON⁄OFF
button or LED ON⁄OFF button.
6.4 Turning LED light on or off
▶ Press the LED ON⁄OFF button to turn on the LED light. To turn the LED light off, press the LED ON⁄OFF
button again.
7 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
20 English 2401892
*2401892*