cecotec EnergySilence Aero 5270 Serie Manual De Instrucciones página 44

ENGLISH
- Ensure that the junction box is securely fastened to the building structure and can
support the full weight of the fan.
- Make sure that the building structure can hold the full weight of the fan.
- This fan can be installed on a normal or vaulted ceiling with a downrod. The hanging
length of the fan can be extended with a longer rod. Fig. 3
- Installation requires the following tools: screwdriver, flat screwdriver, adjustable pliers
or spanner, ladder, wire cutters and electrical tape.
Fig. 3 key:
A. Standard assembly
B. Angle assembly
Installation
Fig. 4 key:
A. Concrete ceiling
1. Self-tapping mounting holes
2. Expansion screws mounting holes
B. Wooden ceiling
1. 4 self-tapping screws
2. Mounting bracket
Fig. 10 key:
1. Canopy fixing screws
2. Mounting bracket
3. Canopy
4. Use a flat screwdriver to tighten the screws.
1. Place the mounting bracket in the position where it is to be installed and mark the point
where the holes are to be drilled.
2. Using a drill, drill two holes 08 mm and 240 mm deep and then insert two plugs.
Note:
- Use plugs or self-tapping screws depending on the roof material. Do not place the
mounting bracket directly on a thin wooden or concrete surface. When the mounting
bracket is in place, make sure that it can withstand more than 60 kg of vertical tension to
avoid any risk.
- You do not need to drill any holes if you are installing in a solid wood ceiling. In this case,
you only need to insert 4 self-tapping screws into the four mounting holes in the corners
of the mounting bracket. Fig. 4
44
ENERGYSILENCE AERO 5270