Buffalo filter PlumeSafe TURBO Auto-Sense Manual Del Operador página 7

5.0 Operating Instructions, Continued
The following items are important for the operation of your system.
POWER ON/OFF
The main power switch is located on the rear panel of your smoke evacuator. This switch completely
enables and disables the main power.
When the unit is powered on the
following LCD screen will appear.
B U F F A L O F I L T E R
I N S E R T V I R O S A F E
F I L T E R
MOTOR ON/OFF
The Motor ON/OFF button is located on the LCD key pad (Figure 1). This button turns the motor (for
suction) on and off.
SUCTION CONTROL
The amount of suction may be adjusted using the UP or DOWN arrow buttons located on the key
pad (Figure 1). Suction may be adjusted up or down by 10% increments. It is recommended that
you select the lowest suction setting that effectively clears the operative field of surgical smoke.
TURBO MODE
The TURBO button is located on the key pad (Figure 1). The amount of suction is significantly
increased when this button is pressed. To return to NORMAL mode, press the TURBO button again.
FILTER LIFE REMAINING
The exact number of hours and minutes remaining on the ViroSafe filter (in use) are displayed on
the LCD screen. When the filter's life is consumed, time remaining will indicate that there are 0 hours
and 0 minutes remaining. This line will continually flash. When the filter life reaches this point, a new
filter with time remaining should be inserted; however, the suction will still work. When the unit's
main power is turned off or the system is left idle for more than 6 hours, a new filter or a filter with
remaining filter life MUST be inserted into the filter basket to allow the unit's suction to turn back on.
After inserting a filter a screen will
flash for a few seconds to indicate
filter type and original life.
B U F F A L O F I L T E R
V I R O S A F E - X L L
1 8 H O U R F I L T E R
When the filter's life is exhausted
the LCD screen will flash
"REPLACE FILTER."
V i r o s a f e - X L L
R E P L A C E F I L T E R 0 0 - 0 0
S u c t i o n S e t t i n g
M o d e - N O R M L M o t o r- O N
Next, the standard screen will
appear which displays information
regarding the unit's current activity.
V i r o s a f e - X L L
T i m e R e m a i n i n g
S u c t i o n S e t t i n g
M o d e - N O R M L M o t o r- O F F
H R - M N
1 0 0 %
H R - M N
1 7 - 3 1
0%
3