Publicidad
Idiomas disponibles
Idiomas disponibles
1 Set MAIN POWER ON/OFF to ON.
2 Press POWER ON/OFF. The radio is turned on.
3 Press FM/AM to select the band (FM or AM).
4 Press DIRECT. The frequency in the display is erased.
5 Enter the frequency of the desired station directly by
pressing the PRESET/DIRECT TUNE buttons 0 - 9. You should
press a button within 10 seconds after pressing the precedent
button.
Minimum entry digit
AM: 1 kHz
FM: 0.05 MHz (50 kHz)
For FM band, decimal point is not required.
For AM band, lower triple zero digits can be omitted.
(See the left examples.)
6 Press EXE.
When the station is tuned in, the tuning indicator appears in the
display.
7 Adjust VOL(volume).
To turn off the radio, press POWER ON/OFF.
The TRY AGAIN Indication
If you input a frequency outside the frequency range, beeps sound and
"TRY" and "AGAIN" are displayed. Press DIRECT and enter the
correct frequency again.
On AM TONE selector
Set AM TONE to NEWS. Vocal will be
heard more clearly. When you are
listening to music, set it to MUSIC. This
function does not work in FM band.
On FM MODE selector (only for
listening through stereo headphones)
For FM reception, normally set FM
MODE to ST (stereo). When it is hard to
hear the broadcast due to noise, set to
MONO (monaural). The reception will
be more state and noise will be reduced.
In this mode, there is no stereo effect.
To Prevent Accidental
Change of the Received
Station
Press KEY PROTECT ©», The
Ow mark
appears in the display window and all
the buttons on the control panel do not
work.
To release the key protect function, press
KEY PROTECT 0 again.
Publicidad
