Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Your specialist dealer will be happy to
help you with the installation.
1. Remove the pre-assembled rollator
from the box and check the contents
as well as the packaging for damage
and completeness.
2. Unfold the frame of the rollator by
pressing the seat down on both
sides until you hear it click into
place.
unscrew the nut below the support and
remove the screw from above. Pull the handle out until the desired distance is reached
and put the nut back into the opening from above. Push it all the way in and tighten the
nut again from below. The distance should be the same on both sides.
5.
the frame using the Velcro
fasteners.
6.
move the bag or empty it comple-
tely and pull the handle on the
seat upwards.
Revision 08/2023
3.
Insert the tubes with the arthritis supports into the
frame parts of the stand. Loosen the knob screw on the
tube support here, push or pull the handle tube to the de-
sired height (holes for fixing) and tighten the knob screw
again. Make sure that the same height is set on both si-
des. The brake cables run parallel to the frame.
4.
To
adjust
the
distance
between the
brake/handle
and
the
arthritis
support,
Attach the bag to the suspension device and to the lower part of
To fold the rollator, re-
7
Publicidad
