Cautions:
e Never mount the unit in any of the following locations to avoid damage due to overheating;
1. Near the heater port.
2. Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
e Do not mount the unit near the door, where it could be exposed to rain.
A Mount the unit on the car carpet by using Velcro Tape (8).
Attach the seal side of the Velcro Tape
to the AV control unit, then mount the unit
on the carpet.
Note : Some carpet materials may not be
suitable for this mounting method. in this
case, please contact your nearest
Panasonic Servicenter for installation.
Velcro Tape
(5) Mounting Bracket
(2) Binding-Head Screw
~
(M5 x 8 mm)
| a the bolts of a
the base bracket
p the carpet.
@ Tapping Screw (M6 x 20 mm)
~ © Double-Faced Adhesive Tape
(6) Base Bracket
Make cuts by
using cutter.
Drill for 4.8 mm diaméter holes to the chassis.
* Put the tape and the base bracket together with each hole of the tape and
bracket connected so that the screw goes in at two positions.
Note : Apply an anticorrosive to the holes and tapping screws.
Caution: You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring
harness, or other component.
47
CA-TU7000U