Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Connections
Wiring Diagram
Cautions:
e This product is designed to operate off a 12 volt, negative ground battery system.
e To prevent damage to the unit, be sure to follow the connection diagram below.
e Remove approx. 1/4" (5mm) of protective covering from the ends of the leads before connecting.
e Do not insert the power connector into the unit until the wiring is completed.
e Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep
cable terminals free from touching any metal parts.
e Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when
the battery terminals are disconnected.
CA-TU7000U
AV Control Unit with
Receiver (Rear)
|
{à Ground Lead
ia
To a clean, bare metallic
part of the car chassis
(Black)
Supplied Hardware
COI CTA
7
>
D
Radio Antenna
1
r
(9) Power Connector
Extension Cord
Front Speaker Cord (Left)
Navi Mute Lead
HEM
MMM
|
Connect to the Navi Mute Lead of
(Orange)
CEE
ANTOONT AKO |
the Panasonic car navigation
(Blue)
system. (not available yet)
:
Front Speaker Cord (Right)
Note: Insulate the Navi Mute Lead
with vinyl tape when you do not
connect it.
Antenna Control Lead
To the auto antenna control power
cord of the car.
Note: Do not connect to the power
supply that controls the auto
antenna directly.
Rear Speaker Cord (Left)
48
Dual CD Changer Control Lead
(not used)
Note: Insulate the Dual CD
changer Control Lead with vinyl
Rear Speaker Cord (Right)
CE
HN
COCOON |
(Brown / white stripe)
External Amplifier Control
(Blue / white stripe)
Power Lead
To an external amplifier
(Fuse 15A)
Battery Lead
I BEN A
u
To the car battery,
Yell
continuous +12V
DC
(Yellow)
(Resistor 2200)
Power Lead
CE
6
El.
1
To ACC power, +12V DC
(Red)
Ground Lead
Sun
To a clean, bare metallic part
pas
Black
of the car chassis
(Black)
CA-TU7000U
Publicidad
