Stiga LT 20 Li B Manual De Instrucciones página 90

Do not leave the machine in the rain (or in
damp conditions).
Remove the battery before performing
any inspections, cleaning or maintenance/
adjustment interventions on the machine.
WARNING! For battery and battery charger
see the dedicated manual
IMPORTANT Any damaged or illegible decals must be
replaced. Order replacement decals from an Authorised
Service Centre
3. ASSEMBLY
IMPORTANT Unpacking and assembly must be
carried out on a flat, solid surface with sufficient space to
move the machine and the packaging.
Before assembling (if necessary), make sure
the batteries are not inserted in their housing
NOTE The machine can be hung on the wall.
• Assembling the charging base
• Mounting of the rail for fixing to the wall (Fig. 3
• Fitting the front hand grip (Fig. 4
NOTE Make sure the front handle was always posi-
tioned below the arrow mark (Fig. 4. D) on labels
• Fitting the guard on the cutting head (Fig. 5)
Wear protective gloves.
Place the guard (Fig.5.A) on the holes on the power unit
base (Fig. 5.B) and fully tighten the screws (Fig. 5.C).
NOTE On the guard of the cutting head there is the
following symbol:
• Fitting the indicator cutting limit (Fig. 6)
Insert and fasten the two ends of the cutting limit
indicator (Fig. 6.A) in their respective holes on the
power unit (Fig.6.B).
Always keep your hands away from the cutting
NOTE
limit indicator
(Fig.2)
)
)
I
ndicates the rotation direction
.
of the cutting head
4. CONTROLS
• Throttle control lever (Fig. 7.A
It allows to start/stop the machine and simultaneously
engages/disengages the cutting head.
The throttle control lever (Fig. 7.A) can only be operated
if the throttle safety lever/button is pressed at the same
time (Fig. 7.B).
• Throttle safety lever/button (Fig. 7.B)
It allows the throttle control lever to be used (Fig. 7.A)
• Speed selector (Fig. 7.C)
It allows you to vary the speed (Two levels).
5. USING THE MACHINE
IMPORTANT For instructions regarding the batteries,
read the relevant manual
5.1. PRELIMINARY PROCEDURES
• Checking the batteries (Fig. 8)
- Before using the machine for the first time after purchase:
fully charge the battery,
- Before each use: check the battery charge status
IMPORTANT Follow the instructions contained in the
battery booklet.
.
The batteries can be charged directly on the ma-
NOTE
chine (para. 6.2).
• Regulating the front hand grip (Fig. 9)
1. Remove the knob (Fig. 9.A) and the support (Fig.
9.B).
2. Move and/or direct the hand grip in the most
ergonomic position for the operator.
3. Tighten the knob.
• Rod length regulation (Fig. 10)
1. Open the clamping hook (Fig. 10.A)
2. Adjust the length of the rod (Fig. 10.B).
3. Close the clamping hook well
• Aligning the cutting head (Fig. 11)
Pressing the button (Fig. 11.A), the cutting device (Fig.
11.B) rotates 90° allowing you to work by switching from
lawn mower mode to edge cutter mode and vice versa.
Perform this operation when the machine is
turned off and the cutting head is still.
IT - 5
.
.