JOCCA 2335 Manual De Instrucciones página 8

EN English
- Install the front grille and joint frame, secure them using the screw on the net
frame. Insert the upper flexible hose into the mist fan located at the front of the
grille (make sure the hose is not kinked).
WATER TANK ASSEMBLY
WATER TANK FILLING
8
- Place the water tank on the mist generator,
making sure it is correctly seated in the space.
- Place the lid on the top of the water tank.
- Insert the lower flexible hose of the fan body
into the water tank cover (make sure the hose is
not kinked).CONTROLLER ASSEMBLY:
- Loosen the two thumb screws located on the
back of the fan header/controller.
- Do not unscrew completely, the two nuts will
fall off.
- Locate the two holes under the fan header/
controller. Assemble the two tubes and push
them down until it stops.
- Tighten the two thumb screws.
- Remove the water tank cover.
- Fill the tank with cold, clean water, being
careful not to fill it more than the MAX mark.
- Put the lid on the tank and place the tank back
on the fog generator.
ATTENTION!
• Make sure the product is unplugged from the
mains before filling or refilling the water tank.
• Only use water in the water tank. Do not add
chemicals, oils or other substances.
• The water should not be hotter than 40°C.