EINHELL TC-PL 750 Manual De Instrucciones Original página 28

new knives when worn down.
•
Some types of planing knives have two bla-
des. When one blade has become blunt, the
planing knife can be turned over.
•
Blunt planing knives cannot be resharpened.
•
Always ensure that you replace both knives at
the same time.
•
Only the original, manufacturer-approved
knife block may be used for this electric hand
plane.
•
Always use only clean and sharp planing kni-
ves to ensure professional, safe results.
Do not lose these safety regulations.
2. Layout and items supplied
2.1 Layout (Fig. 1/2)
1. Setting knob for the chip depth
2. Chip ejector
3. Safety lock-off
4. On/Off switch
5. Rear base plate
6. Belt cover
7. Parking soleplate
8. Front base plate
9. Thumb screw for step depth scale
10. Step depth scale
11. Parallel stop
12. Wrench
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
Anl_SA_TC_PL_750_SPK8.indb 28 Anl_SA_TC_PL_750_SPK8.indb 28
GB
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Hand-held electric plane
•
Parallel stop
•
Wrench
•
Step depth scale
•
Original operating instructions
3. Proper use
The hand-held electric plane is designed for pla-
ning, rabating and chamfering pieces of wood.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage:
BR: ...................................... .......... 220 V ~ 60 Hz
BR: ..................................... .......... 127 V ~ 60 Hz
AR: ...................................... .......... 220 V ~ 50 Hz
CL: .................................... ........... 220 V ~ 50 Hz
CO: ..................................... .......... 120 V ~ 60 Hz
PE: ..................................... ........... 220 V ~ 60 Hz
Power input: ............................................... 750 W
Idling speed: ..................................... 17000 min
Chip depth: .............................................. 0-2 mm
Rebate depth: ........................................ 0-10 mm
Plane width: .............................................. 82 mm
Protection class: ............................................ II/
Weight: .......................................................2.4 kg
- 28 -
-1
02.11.2023 13:30:52 02.11.2023 13:30:52