Publicidad
Idiomas disponibles
Idiomas disponibles
Setting up and connecting
10.2 Setting up the appliance
Place the appliance in accordance with the prescribed minimum clearances.
Set up the appliance in a dry, well-ventilated room whose ambient temperature
corresponds to the climate class for which the appliance is designed.
ATTENTION
APPLIANCE DAMAGE!
Leave the appliance to stand for 12 hours after transport to allow the refrigerant to
collect in the compressor. Failure to observe this may damage the compressor and cause
the appliance to fail. This would void all warranty claims.
CLIMATE CLASS
(SN) Extended temperature range
(N) Temperature range
(ST) Subtropical temperature range
(T) Tropical temperature range
Minimum clearances for ventilation
Air circulation at the rear, side and top of the appliance influences energy consumption
and refrigerating/freezing performance (depending on model). It is essential that the
minimum clearances for ventilation of the appliance are observed as shown in the
following drawing. If the minimum clearances are not observed, the accumulated air
cannot escape and the compressor is in continuous operation, which shortens the life of
the appliance.
➢ In order not to impair the function of the appliance, never cover or
➢ To ensure adequate ventilation, it is important that the clearance
➢ To achieve the specified energy class, comply with the above
➢ Do not install refrigerator/freezer combinations with only one
For more information on installation, see the installation instructions supplied
block the ventilation openings/slots of the appliance cover.
between the wall and the front edge of the appliance is not less
than 60 cm.
mentioned clearances.
temperature regulator in refrigerated rooms below 16 °C.
Page 32 of 48
TEMPERATURE RANGE
+10 °C to +32 °C
+16 °C to +32 °C
+16 °C to +38 °C
+16 °C to +43 °C
Publicidad
