Publicidad
Idiomas disponibles
Idiomas disponibles
, IPORE
YOU
ALL
FOR
FIRST:
° Check if oven controB have been prop-
erIy set.
° Check to
be
sure plug is securdy inserted
into
receptade.
• Checkor re-setdrcuitbreaker.
Checkor
replace
fuse.
° Check power supply.
PART OR ALL OF APPLIANCE
DOES
NOT WORK,
° Check if surface and/or oven controb
have been properly set. See pgs. 5 & 10.
° Check if oven door is unlocked after serf-
dean cycle. See pg. [8.
• Check if oven is set for a delayed cook or
dean program. See pgs. [ 4 & [ 8.
• Check ifControl Lock is activated. See pg.
II.
BAKING
RESULTS
ARE
NOT
AS
EXPECTED
OR
DIFFER
FROM
PREVIOUS
OVEN.
° Hake sure the oven vent has not been
blocked. See pg. 8 for location.
° Check to make sure range is level.
• Temperatures
often vary between a new
oven and an old one. As ovens age, the
oven temperature
often "drifts" and may
become hotter or cooler. See pg. 12 for
instructions
on adjusting the oven tem-
perature.
NOT£: It is not recommended
to adjust the temperature
if on[), one or
two recipes are in question.
° Check that oven temperature
is decreased
by 25° Fwhen convect baking.
° See "Cooking Made Simple"
booklet
for more information on bakeware and
baking.
• Hake sure oven is preheated when recipe
or directions recommend preheat.
• Check rack positions. See page 17.
FOOD
IS NOT
BROILING
PRO-
PERLY OR SMOKES EXCESSIVELY.
• Check oven rack positions. Food may be
too dose to dement.
° Aluminum foil was incorrecdy used.Never
line the broiler insert with foil
• Trim excessfat from meatbefore broiling.
° A soiled broiler pan was used.
OVEN
WILL NOT
SELF=CLEAN.
° Check to make sure the cycle is not set for
a delayed start. See pg. [ 8.
• Check if door is closed.
OVEN DID NOT CLEAN PROPERLY.
° Longer cleaning time may be needed.
• Excessive spillovers, especially sugary and/
or acid foods, were not removed prior m
the self-clean cycle.
OVEN
DOOR
WILL NOT UNLOCK
AFTER
SELF-CLEAN
CYCLE.
° Oven interior is sq[[hot. Allow about one
hour for the oven to coo[ after the comple-
tion of a serf-dean cycle. The door can be
opened when the LOCK indicator word is
not displayed.
I_/_OISTURE
COLLECTS
ON OVEN
WINDOW
OR STEAM COMES FROM
OVEN VENT.
• This is normal when cooking or drying
foods high in moisture.
° Excessivemoisture was usedwhen dean-
ing the window.
SURFACE
OR GRILL BURNER FALLS
TO LIGHT.
° Check to be sure burner ports or ignition
ports are not clogged. See page 20.
° Checkto be sure ignitor is dryand clicking.
Burner wi[[ not tight if ignitor is damaged,
soiled or wet. If ignitor doesn't dick, turn
control [<nobOFF.
SURFACE
OR GRILL BURNER
FLAME LIFTS OFF PORTS.
° Check m be sure a pan is sitting on the
grate above.
• Contact an authorized Jenn-Air servicer.
THE
FLAME IS UNEVEN.
• Burner ports may be clogged.
SURFACE
OR GRILL BURNER
FLAME IS YELLOW IN COLOR.
• Contact an authorized Jenn-Air servicer.
• Some yellow tips on the flame are accept-
able when using LP gas.
22
THERE
IS A STRONG
ODOR
OR
LIGHT
SMOKE WHEN
OVEN IS
TURNED
ON.
• This is normal for a new range and wiil
disappear after a few uses.
[niqadng a
clean cycle will "burn off" the odors more
quickly.
• Turning on a ventilation
fan will help
remove the smoke and/or odor.
• Excessive food soils on the oven bottom.
Use a self-clean cycle.
VENTILATION
SYSTEM
IS NOT
CAPTURING
SMOKE EFFICIENTLY.
• Check on cross ventilation
in room or
make up air.
• Excessive amount of smoke is being cre-
ated; check instructions for grilling, trim-
ruing meats. See pg. 8.
• Outside wall cap may be trapped shut.
• Range may be improperly installed; check
ducdng information. See pg. 4.
• Air filter may be improperly installed. See
pg. 8.
a
FAN SOUND
CAN BE HEARD
• This is the cooling fan and is normal The
fan wiil continue to run after use until the
oven
cools.
"F p* PLUS A NUMBER
AND
THE
MESSAGE:
"CALL
AN
AUTHO-
RIZED SERVICER OR 800-688-1100."
• This is called a fauk code. If a fauk code
appears in the display and beeps sound,
press the Cancel
pad. If the fault code
and beeps continue, disconnect power to
the appliance. Wait a few minutes, then
reconnect power. Iffauk code and beeps
still continue, disconnect power to the
appliance and call an authorized servicer.
• If the oven is heavily soiled, excessive
flare-ups may result in a fauk code during
a clean cycle. Press Cancel pad and allow
the oven m cool for one hour, then reset
the clean cycle. Ifthe fauk code and beeps
still continue, disconnect power to the
appliance and call an authorized servicer.
Publicidad
